VORTEX Screen Protector Install Guide

VORTEX screen protector installation guide

A cleaner install starts with the right preparation. Give it a few minutes, work in a clean well-lit spot, and take the steps slowly.

Before you start

• Make sure the protector matches your exact iPhone model.

• Wash and dry your hands.

• Keep the phone away from dust and moving air.

• Lay out the cleaning wipes and the alignment frame included in the box.

Installation steps

1. Remove the case and clean the screen with the wet wipe.

2. Dry the screen with the microfiber cloth until no moisture remains.

3. Run the dust-removal sticker across the whole screen, especially the edges.

4. Place the phone inside the alignment frame in the direction shown on the box.

5. Follow the pull or press marking on the installation tool to set the protector.

6. Wait a moment, lift the frame away, then push any small bubbles gently toward the nearest edge.

After installation

Let the protector settle before putting the case back on, and check that no dust is trapped underneath. Small air bubbles usually disappear on their own. A trapped dust particle needs the nearest corner lifted carefully and the dust sticker used again.

Important

Installation tools differ between product models, so the printed instructions in your box take priority over this guide if they differ. Do not use sharp tools or heavy pressure on the screen.